0800 368 0771
0800 368 0771
Rotation: Anti Clockwise Nozzle Port: Left Hub: 54mm Shaft Diameter: 8mm The SUNTEC AS oil pump has a built in solenoid valve which controls th...Vollständige Details anzeigen
Rotation: Clockwise Nozzle Port: Right Hub: 32mm Shaft Diameter: 8mm The SUNTEC AS oil pump has a built in solenoid valve which controls the re...Vollständige Details anzeigen
The Suntec AP Series of pump are a light oil pump designed for use on a 1 or 2 pipe system. Suntec AP pumps have built in solenoids allowing a high or low pressure supply through the same nozzle.
High Pressure Mode
This is actuated with the solenoid valve activated (ie. closed); activating this solenoid valve closes the by-pass channel to the return. Oil is then transferred to the nozzle line at the pressure given by the high pressure regulating valve.
Low Pressure Mode
The low pressure actuates with the solenoid valve open (ie. non activated); the by-pass channel is open, the oil is supplied to the nozzle line via the by-pass hole and the low pressure adjustment is made by the screw on the solenoid tube. It is preferable to set the high pressure given by the pump valve (with solenoid activated) before the low pressure, with solenoid non activated.
Care should be taken not to overtighten the low pressure adjusting screw of the solenoid tube, as this may eliminate the low pressure range. For two pipe installation, the by-pass plug fitted in the return port allows any oil not required at the nozzle to be dumped back to the tank. For one pipe installation, the by-pass plug must be removed and the return port plugged, oil which is not required at the nozzle is then returned back to the suction port in the gear set.
Rotation of these pumps is determined by viewing the pump from the shaft end.
If the Part number has a K at the end, it is suitable for use with Kerosene.
If the Part Number has a V in, it is fitted with Viton Seals.