Skip to content
Buy Now Pay Later with Klarna
Buy Now Pay Later with Klarna

Suntec J Series Pumps

Filters

  • Suntec J4 CDC 1001-Fuel Pump

    Suntec J4 CDC 1001

    Suntec
    £225.09

    Rotation: Anti Clockwise Nozzle Port: Right Hub: 54mm Pressure Range: 10-21 bar Shaft Diameter: 11mm   The SUNTEC J oil pump incorporates a pres...

    View full details
  • Suntec J6 CDC 1000-Fuel Pump

    Suntec J6 CDC 1000

    Suntec
    £262.20

    Rotation: Anti Clockwise Nozzle Port: Right Hub: 54mm Pressure Range: 10-21 bar Shaft Diameter: 11mm   The SUNTEC J oil pump incorporates a pres...

    View full details
  • Suntec J6 CCC 1001-Fuel Pump

    Suntec J6 CCC 1001

    Suntec
    £164.75

    Rotation: Anti Clockwise Nozzle Port: Left Hub: 54mm Pressure Range: 10-21 bar Shaft Diameter: 11mm   The SUNTEC J oil pump incorporates a press...

    View full details
  • Suntec J6 CCE 1002-Fuel Pump

    Suntec J6 CCE 1002

    Suntec
    £262.20

    Rotation: Anti Clockwise Nozzle Port: Left Hub: 54mm Pressure Range: 10-30 bar Shaft Diameter: 11mm   The SUNTEC J oil pump incorporates a press...

    View full details
  • Suntec J7 CCC 1001-Fuel Pump

    Suntec J7 CCC 1001

    Suntec
    £164.02

    Rotation: Anti Clockwise Nozzle Port: Left Hub: 54mm Pressure Range: 10-21 bar Shaft Diameter: 11mm   The SUNTEC J oil pump incorporates a press...

    View full details
  • Suntec J7 CAC 1001-Fuel Pump

    Suntec J7 CAC 1001

    Suntec
    £267.25

    Rotation: Clockwise Nozzle Port: Right Hub: 54mm Pressure Range: 10-21 bar Shaft Diameter: 11mm   The SUNTEC J oil pump incorporates a pressure ...

    View full details

Suntec J Series Pumps

The Suntec J Series pumps are designed for use with light or medium oil. They are suitable for use with a one or two pipe system and are usually used with an in-line solenoid valve.

Cut-Off Function

The valve also has a cut-off function* as follows : During starting period when the gear-set speed is increasing, all the oil passes through a special flat on the piston, back to the return. Once the speed reaches a certain value and the flow can no longer pass through this flat, then the pressure increases rapidly overcoming the valve spring force and opens the valve. During the stop sequence, the gear-set speed slows down and the valve closes when the gear-set capacity is lower than the flat flow. The cut-on and cut-off speeds depend on the gear-set size and set pressure.

Rotation

Rotation of these pumps is determined by viewing the pump from the shaft end.

Pump Options

If the Part number has a K at the end, it is suitable for use with Kerosene.

If the Part Number has a V in, it is fitted with Viton Seals.

SUNTEC J Series Pump